Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Threading the Machine
• Threading
the machine
*
Raise the thread take-up lever to its highest position
by turning the handwheel counterclockwise,
toward
you_
*
Raise the presser foot lifter,
*
Place a spool on the spool pin, with thread coming
off as shown,
[]
Draw the end of the thread around the upper thread guide
[]
While holding the thread near the spool, draw the end of the
thread down around the check spring holder.
[]
Firmly draw the thread up from right to left over the take-up
lever and down into the take-up lever eye,
[]
Slide the thread behind the needle bar thread guide on the
lefto
[]
Thread the needle from front to back or use a needle
threader.
We recommend using the convenient needle threader
(#200262101),
included with your machine.
o Drawing up bobbin thread
[]
Raise the presser fool Hold the needle thread lightly with
your left hand and turning the handwheet countercloc!oMse,
toward you, for one complete turn.
[]
Bring the bobbin thread up by pulling the needle thread up.
[]
Pull both threads under and to the back of the presser foot,
leaving 10 cm to 15 cm (4 to 6 inches) of thread clear
[]
[]
[]
%,,
!
J
24
Tabla de contenido
