Free-Arm Sewing; For Free-Arm Sewing; For Flat-Bed Sewing; Changing Needle - Sears Kenmore 385.12618 Manual De Instrucciones

Free-arm Sewing
t For free-arm sewing:
1. Grip the extension table with your index finger and
thumb.
2 Pull gently to the left.. The extension table will snap
out.
• For flat-bed sewing:
, Insert the tab and the pin into their catches,
With your thumb and index finger, gently snap in,
Changing Needle
0 Needle clamp screw
(_) Pin
(_ Needle clamp
[] Turn off the power switch.
Raise the needle to its highest position by turning
the handwheel counterclockwise, toward you, and
lower the presser foot
Loosen the needle clamp screw 0 by turning it
counterclockwise.
Remove the needle from the clamp(_)
[] Insert a new needle into the needle clamp(_ with
the flat side to the rear_
When inserting the needle into the needle clamp
0, push it up as far as it goes Tighten the needle
clamp screw 0 firmly by turning it clockwise
[] To check for a good needle, place the flat side of
the needle onto something fiat (needle plate, glass,
etc.)
The gap between the needle and the flat surface
should be consistent.. Never use a bent or blunt
needle.
A damaged needle can cause permanent snags
or runs in knits, fine silks and silk-like fabrics.
Changing Presser Foot
(_) Presser bar
(_) Thumb screw
To change the presser foot, raise the presser bar.
Loosen the thumb screw, choose the proper foot and
insert from the bottom_
Tighten the thumb screw using the large screwdriver
to make certain the foot is secure
10
[]
[]
%.
f-
,,,J
.... J