Tabla de contenido
Threading
the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with the thread coming
off as shown.
[] Draw the end of the thread around the upper thread guide.
[] While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[] Firmly draw the thread up from right to left over the
take-up lever, and down into the take-up lever eye.
[] Slide the thread behind the needle bar thread guide on
the left.
%Thread
the needle from front to back, or use a needle
threader.
• Needle threader
_1_Knob
Hook
<_ Guide
[] Pull the handwheet out to the right. Lower the presser
foot. Raise the needle to its highest position.
Pull down
the needle threader knob as far as it will go.
[] Turn the knob in the direction of the arrow in the
illustration, and insert the hook,into
the needle eye.
Lead the thread around the guide _ and under the
hook _.
[] Turn the knob in the direction of the arrow in the
illustration, drawing the thread loop through the needle.
[] Paying close attention to the needle point, draw the
thread through the needle eye. You will find it helpful to
use a pointed instrument, such as the seam ripper tip, to
draw the thread through the needle eye. Push in the hand
wheel and prepare to sew.
The needle threader can be used with a #11 to #16
needle, or a #11 Blue needle.
Thread size 50 to 100 is recommended.
S
[]
f
[]
S
[]
[]
[][]
\
lr
\
J
J
26
Tabla de contenido
