Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Bar Tacking
(_
Stitch selector:
C
(_) Stitch length:
0.5 to 1
(_
Needle thread tension: 1 to 4
®
Presser foot:
Zigzag foot
This is similar to a very short satin stitch and is used
to reinforce points of strain such as corners, pockets
and straps of lingerie,
Sew four (4) to six (6) stitches°
Button Sewing
0
Stitch selector:
B to C
_) Stitch length:
Any
(_
Needle thread tension: 1 to 4
(_
Presser foot:
Zigzag foot
(_) Darning Plate
Using the Darning (p, 38)
1_ Set the stitch selector at "B"
2, Match the holes on a button with the horizontal slot of
the zigzag foot and place the left hole of the button just
below the needle point of" B"
3o Lower the foot and turn the stitch selector to zigzag until
the needle point comes just above the right hole of the
button
4. Sew about five stitches then raise the needle,
5. Set the stitch at" B" again and sew a few stitches to
lock the thread.
To strengthen the shank, cut the threads leaving about
10 cm (4"). Bring the needle thread down through one of
the holes on the button and wind it around the shank,
Bring the needle thread to the wrong side (bottom side)
and knot.
r
%.
f
®
TYPE
©
®
®
LENGTH
©
,J
,,,J
0
®
TYPE
LENGTH
®
®
J
44
Tabla de contenido
