Idiomas disponibles
Idiomas disponibles
G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
1. Package Contents
• 433 MHz radio-controlled socket
• These operating instructions
2. Safety Notes
• Do not connect units in series
• Do not cover when in use
• There is voltage running through the socket unless
it is unplugged
• Only switch on and use with the safety covers
closed
• Do not use the radio-controlled socket if there is
visible damage to the housing
• Repair work may only be performed by qualified
experts or a specialist retailer
• Use the device in dry rooms/indoors only.
3. Connecting and getting started
Note
On extending Hama radio-controlled socket
sets. It cannot be guaranteed that radio remote
controls of other manufacturers will work.
Now plug the radio-controlled socket into an earthed
socket.
To test the radio-controlled socket and for manual
use without a remote control, press the "On/Off"
button. When the button is pressed, the LED of the
radio-controlled socket should light up. When you
press the button again, the LED should go out.
This product is for indoor use only.
4. Learn function of the radio-controlled socket
Press and hold the "LEARN" button for approx.
3 seconds until the LED starts to flash. Then select
the desired channel by pressing the corresponding
"ON" button.
2
The LED on the radio-controlled will stop blinking
when it has successfully learnt the frequency.
If the learning is unsuccessful, the remote control
socket will leave learn mode after 15 seconds. In this
case, repeat the process. It is also possible to assign
a channel multiple times (multiple radio-controlled
sockets can respond to the same remote control
button).
If you wish to delete a programmed channel, first
press the "LEARN" button until the LED flashes.
Press the "OFF" button for the channel to remove its
programming.
5 Troubleshooting
5.1 Remote control does not work
Check whether the battery has been inserted with
the poles facing the proper directions. You can check
this by making sure that the label on the battery
corresponds to the polarity marked inside the battery
compartment.
If the control LED on the remote control does not
light up when you press a button, even when the
battery has been inserted correctly, then it is possible
that the remote control has a technical defect. If this
is the case, please contact our customer service team
or the retailer where you purchased this product.
5.2 The radio-controlled socket cannot be
switched on or off even though the remote
control is working properly
Repeat the steps above under "Learn function of the
radio-controlled socket" and, if necessary, contact
Hama technical support or the retailer where you
purchased this product.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
