Makita 2705 Manual De Instrucciones página 11

3. Once the locking lever pin is placed into the notch
provided on the blade guard assembly it is to be
locked into position by pushing the tab of the pin's
locking lever into the locked position as shown in
Figure 3.
► 1. The locking lever in the locked position
To remove the blade guard for non through cutting
operations reverse the above steps 1-3.
Antikickback Pawl Operation
WARNING:
Use the Antikickback pawls whenever pos-
•
sible during the through cutting operations.
This will help prevent the material from being
pushed forward into the operator during a
kickback situation which may result in serious
personal injury.
Fig.1
1
► 1. The blade guard assembly item 1 is provided with
two on board antikickback pawls item 2. The pawls
are located on either side of the blade and can be
stored or put into operation independently for ease
of operation
1
► 1. Item 1 illustrates the antikickback pawl on the
right side of the blade being lifted and placed into
the pawl holder located at the back of the blade
Fig.3 guard assembly. 2. In addition item2 illustrates
the antikickback pawl on the left side of the blade
remaining in the operational position.
► 1. Item 1 demonstarates both antikickback pawls
being lifted and placed into the pawl holders located
at the back of the blade guard assembly for storage
2
3
► 1. Item 1 indicates the location of the antikickback
pawl holders located at the back of the blade guard
assembly 2. Item 2 points to the arrow direction
which should be followed when taking the pawls
out of the storage position and placing them into
operation 3. Item 3 indicates the direction of which
the pawls should be lifted when storing and placing
them into the antikickback pawl holders
11 ENGLISH
1
1
2
2
Fig.2
Fig.3
1
Fig.4