Idiomas disponibles
Idiomas disponibles
English
1
2
► Push the battery (2) into the charger (3) until it
stops.
The LED on the charger glows green when the
battery is charging.
The LEDs (1) on the battery glow green and
show the state of charge.
When the LEDs on the battery go out, the
charging process is complete and the charger
will shut itself off. The battery can be removed
from the charger.
► Disconnect the power supply cord from the
electrical outlet when the charger is not in use
for extended periods of time.
► Charge STIHL AP series batteries only with
genuine STIHL AL 101, AL 301, AL 301-4 or
AL 500 series chargers.
11 LED Diagnostics and
Acoustic Signals
11.1
STIHL AP Battery
11.1.1
Battery Status
Four LEDs show the status of the battery. These
LEDs can glow or flash green or red.
If one LED glows red continu‐
ously: the battery is either too hot
or too cold. Allow the battery to
warm up or cool down gradually at
an ambient temperature of about
50 °F to 68 °F (10 °C to 20 °C).
If all 4 LEDs flash red: the battery
has a malfunction and must be
replaced. Do not attempt to
charge, use or store the battery.
11.1.2
Power Tool Status
The same LEDs on the battery will indicate the
status of the power tool.
If three LEDs glow red continuously: the power
tool motor is too hot. Allow the motor to cool
down.
If three LEDs flash red when you activate the
trigger switch: the power tool has an electrical
malfunction. Do not operate the power tool. Have
14
3
4
11 LED Diagnostics and Acoustic Signals
it checked by an authorized STIHL servicing
dealer before use or storage.
For troubleshooting information,
11.1.3
Charge Status
The LEDs on the battery also show the battery's
state of charge.
To determine the battery's state of charge:
1
► Press the button (1) on the battery.
The LEDs on the battery will glow or flash
green for about 5 seconds and indicate the
state of charge (see illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 %
charge.
12 Assembling the Shredder
Vac
12.1
Mounting the Nozzle
WARNING
■ Make sure the battery is removed before start‐
ing assembly. Never operate your shredder
vac without a properly mounted nozzle,
6.6.4. Use only attachments supplied or
expressly approved by STIHL,
To mount the nozzle:
3
2
5
► Align the holes on the suction tube (4) with the
lugs on the nozzle (5).
The arrows (3) should point to each other.
22.
80-100%
60-80%
40-60%
20-40%
0-20%
6.5.
1
3
4
0458-045-8601-A
