Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Using proper cookware
The size and type of cookware used will influence the
setting needed for best cooking results. Be sure to follow
the recommendations
for using proper cookware as
illustrated in Figs. 1 & 2.
Cookware should have flat bottoms that make good contact
with the entire surface heating element (See Fig. 2). Check
for flatness by rotating a ruler across the bottom of the
cookware (See Fig. 1). For more information about the
ceramic cooktop see "Cooktop Cleaning & Maintenance" in
the General Care & Cleaning
section.
Fig. 1
The type and size of cookware, the number of surface
elements in use and their settings are all factors that will
affect the amount of heat that will spread to areas beyond
the surface elements. The areas surrounding the elements
may become hot enough to cause burns.
Element ON and Hot Surface Indicator
Lights
Your appliance is equipped with two different types of
radiant surface control indicator lights that will glow on the
backguard -- the Element On indicator light and the Not
Surface indicator lights.
The Element ON indicator
lights are located on the
control panel above each radiant element control knob and
will glow when a surface element is turned ON. A quick
glance at this indicator light after cooking is an easy check
to be sure ALL surface controls are turned OFF. The Hot
Surface indicator light located on the control panel will
glow when any surface cooking area heats up and will
remain on until the glass cooktop has cooled to a
MODERATE level.
Good Cookware
Poor Cookware
o
o
o
o
®
®
11"
t
Flat bottom
and straight
sides,
Tight fitting lids,
Weight of handle does
not tilt pan. Panis well
balanced,
• Curvedand warpedpan,
o Pan larger than cooking area
marked on cooktop by more
than one-half inchor 12mm.
Pan sizes match the
amount of food to be
prepared and the size of
o Heavy handle tilts pan,
the surface element.
Made of a material that
conducts heat well,
Easy to clean,
e Pan is smaller or larger
Always match pot
than heating area marked
diameter to element size.
on cooktop.
Fig. 2
About the ceramic glass cooktop
The ceramic cooktop has radiant surface elements located
below the surface of the glass. The design of the ceramic
cooktop outlines the area of the surface element
underneath. Be sure to match the pan size with the
diameter of the element outline on the cooktop and only
flat-bottomed cookware should be used.
Element
ON Indicator
Lights
©
SIM
__
@
_
Hot Surface
OFF
MED
Note:
Radiant elements have a limiter that allows the element
to cycle ON and OFF, even at the HI setting. This helps
to prevent damage to the ceramic smoothtop. Cycling
at the HI setting is normal and will occur more often if
the cookware
is too small for the radiant element or if
the cookware bottom is not flat.
•
Be sure to read the detailed instructions for ceramic
glass cooktop cleaning in the Cleaning
and
Maintenance section of this Use & Care Manual.
Types of cooktop elements
The ceramic glass cooktop has radiant surface elements
located below the surface of the glass. The patterns on the
ceramic glass will outline the size and type of element
available. The single radiant element will have one round
English 15
Tabla de contenido
