Idiomas disponibles
Idiomas disponibles
EN
CONNECT NMX-WP PANELS
In order to detect a wall panel with the PC software, the following aspects must be taken into account:
-
The NMX-WP wall panel shall be associated to an NMX Matrix and this matrix shall be connected to the
correct IP address.
-
PC, NMX-WP and NMX Matrix must be on the same network.
1.- In the PC software, go to the SETTINGS > PANEL SETTINGS menu and a new window will appear.
2.- On the right-hand side of the new window you can see the NMX-WP wall panels detected in the network
at the top. As with the matrices, the software detects wall panels that are physically connected to the
same network but may not have the correct network confi guration. We must ensure that the network
settings set in the wall control correspond to the same network that we are confi guring in the rest of the
equipment. To do this, click on the SET IP button and confi gure DEVICE IP ADDRESS, NETMASK and
GATEWAY. And click on the OK button to save the confi guration.
3.- To link the wall panel to a matrix, click and drag the devices from the right panel (wall remotes at the
top, matrices at the bottom) to the centre of the screen. Finally, join the points that have both drawings
and a line will be created between them.
NOTE: if the pictures appear grey, not as shown in the image below, it means that they are not properly
connected, check the network confi guration and the physical cables connecting the devices.
- 6 -
