Idiomas disponibles
Idiomas disponibles
EN
LAUNCH SOFTWARE
1.- Connect the matrix and a PC via a switch or router.
2.- Double-click on the application icon to start the programme and select the matrix model you want to
configure. This selection will load the appropriate configuration panel for the specified matrix and then
bind the matrix to it. If you have more matrices, you can add them later.
NOTE: it may take a few seconds the first time you start the programme.
3.- The programme will then display the main screen.
CONNECT AN NMX MATRIX
1.- In the PC software, in the upper right corner, you will find DEVICE LIST which will show you all active
matrices physically connected to the same network as the PC and which are automatically detected by
UDP discovery.
NOTE: each matrix supports up to 4 simultaneous control connections (PCs).
To add new matrices you can either click the
or click the
button to refresh the list of matrices (recommended).
2.- In this list you can see the matrices whose configuration can be modified by pressing the SET IP
button. On the pop-up screen, you can enter the DEVICE IP ADDRESS and NETMASK to configure the
matrices on the same network as the PC.
button and manually enter the IP address of the matrix
- 4 -
