▪
If the direction of fall cannot be reliably estimated owing to wind or gusts of wind. Felling
work on sloping ground, black ice, frozen or dewy ground is safe only if you can get a firm
foothold.
12
CLEANING AND MAINTENANCE
Always pull the plug out of the power socket before doing any work on the
chainsaw!
▪
Keep the cooling vents on the motor housing clean and unobstructed at all times.
▪
Only the maintenance work described in these operating instructions may be carried out.
Any other maintenance work must be carried out by our Customer Service.
▪
Do not modify the power saw in any way as this could jeopardize its safety.
▪
Should the chainsaw fail despite our careful manufacturing and inspection procedures
have it repaired by an authorized Customer Service work-shop.
13
TROUBLESHOOTING
FAULT
Motor does not
run
Chain does not
move
Poor cutting
performance
Saw works only
with difficulty
Chain jumps off
sword
Chain becomes
hot
Copyright © 2024 VARO
CAUSE
No electricity
Chain brake
Running out of
carbon brush
Chain brake
Blunt chain
Chain tension
Check that the
chain is fitted
correctly
Chain tension
Chain lubrication
P a g e
POWXG1009
REMEDY
Check socket, cable and plug .
Damaged cable: Have repaired by Customer
Service. It is prohibited to patch the cable with
insulating tape.
Damaged switches have to be replaced by a
Customer Service workshop.
See section "chain brake" and "Releasing the
chain brake"
Change the carbon brush, ask a Customer
Service workshop
Check the chain brake, release if necessary.
Sharpen the chain
Chain wrongly fitted
Check the chain tension
Check the chain tension
Check oil level
Check Chain lubrication
| 12
EN
www.varo.com
