Idiomas disponibles
Idiomas disponibles
22. NEVER use any PPE to hang, lift, support, or hoist tools or equipment unless that equipment is explicitly certified for such
use.
23. When more than one Person Fall Arrest System is attached to an anchorage, the anchorage strengths set forth of the
requirement (12 kN) and must be multiplied by the numbers of systems attached to it.
24. Connect to the anchor point and other equipment must be through to the connector in conformity to EN 362:2004.
25. Before each use of personal protective equipment, it is obligatory to carry out a pre-use check of the equipment, to ensure
that it is in a serviceable condition and operates correctly before it is used.
26. During pre-use check it is necessary to inspect all elements of the equipment in respect of any damages, excessive wear,
corrosion, abrasion, and degradation due to UV, cuts or misuse, especially take into account webbings, seams, anchor D-
rings, buckles and adjusting elements. Defective components must be removed from service immediately, if it can be
removed.
27. Thoroughly evaluate and plan all elements of your fall protection systems before using your equipment. Make sure that
your system is appropriate for your needs and facility. Also be sure to calculate fall clearance and swing fall clearance.
28. Store the equipment in a cool, dry, and clean environment that is out of direct sunlight when not in use.
29. When the equipment becomes wet, either from being in use or when due to cleaning, it shall be allowed to dry naturally,
and shall be kept away from direct heat.
30. The regular periodic examinations is needed. The safety of users depends upon the continued efficiency and durability of
the equipment. And the
in accordance with the manufacturer's periodic examination procedures.
31. Physical harm may still occur even if fall safety equipment functions correctly.
periodic examinations are only to be conducted by a competent person and should be strictly
