Idiomas disponibles
Idiomas disponibles
Standards Compliance
Model No.
VIKCC-W
VIKAA-H
Note: FBH - Full Body Harness
These models EU Declaration of Conformity can be found at www.vito-tools.com.
WARNING
Must provide this instruction to users, then read and understand it carefully before using this equipment. Failure to follow as
below warnings on the use of this equipment may result in serious injury or death:
1.
The persons who are suffering from high blood pressure, heart disease, severe anemia, acuity, etc. are forbidden doing
aloft work. The people who is tired, poor eyesight and drunk is not allowed doing aloft work too. People who are in a state
of mental agitation, panic and anxiety are not allowed to work at high altitude for the time being.
2.
The equipment shall only be used by a person trained and competent in its safe use.
3.
A rescue plan shall be in place to deal with any emergencies that could arise during the work.
4.
Against to make any alterations or additions to the equipment without the manufacturer's prior written consent, and that
any repair shall only be carried out in accordance with manufacturer's repair procedures. These procedures must be
provided to service provider by manufacture.
5.
The equipment shall not be used outside its limitations, or for any purpose other than that for which it is intended.
6.
Before use ensure about the compatibility of items of equipment when assembled into a system. Ensure that all items are
compatible and appropriate for the proposed application. It is forbidden to use combinations of items of equipment in
which the safe function of any one item is affected by or interferes with the safe function of another. Periodically check
the connection and adjustment of the components to avoid accidental disconnection and loosening.
7.
The equipment must be withdrawn from use immediately when any doubt arise about its condition for safe use and not
used again until confirmed in writing by a competent person that it is acceptable to do so.
8.
Personal protective equipment must be withdrawn from use immediately when it has been used to arrest a fall.
9.
It is essential for safety that the anchor device or anchor point should always be positioned, and the work carried out in
such a way, as to minimize both the potential for falls and potential fall distance.
10. It is essential for safety to verify the free space required beneath the user at the workplace before each occasion of use,
so that, in the case of a fall, there will be no collision with the ground or other obstacle in the fall path.
11. There are many hazards that may affect the performance of the equipment and corresponding safety precautions that
have to be observed e.g.: extremes of temperature, trailing or looping of lanyards or lifelines over sharp edges, chemical
reagents, electrical conductivity, cutting, abrasion, climatic exposure, pendulum falls.
12. It is essential for the safety of the user that if the product is re-sold outside the original country of destination the reseller
shall provide instructions for use, for maintenance, for periodic examination and for repair in the language of the country
in which the product is to be used.
13. When the equipment only conforms to EN 361:2002, it is only used for fall arrest but not for work positioning or
suspension.
14. When the equipment only conforms to EN 358:2018 (e.g. Waist belt), the full-length range in 130-140 cm, the usage range
is between 70-85 cm, and the waist belt is designed for users with a maximum capacity up to 150 kg, including tools and
equipment. If the harness is not suitable for fall arrest purposes, and that it may be necessary to supplement
arrangements for work positioning or restraint with collective means (e.g. safety nets) or personal means (e.g. fall arrest
systems in accordance with EN 363) of protection against falls from a height.
Standard Ref.
Type
EN
361:2002
Waist
Belt
FBH
√
EN
EN
358:2018
813:2008
√
EN
1497:2007
