cecotec ENERGYSILENCE AERO 5290 NATURAL Manual De Instrucciones página 49

- Use the speed buttons to select the air power level.
- Press the power button to turn the appliance off.
- Use the timer buttons to select the fan operating time. The fan will turn off once the
selected time has elapsed.
- Press the light button to turn the fan's lamp on and off.
Winter Function
Press button 3 to activate the winter function. The fan will make air flow from the bottom
upwards, bringing cold air to the top of the room.
Summer Function
Press button 4 to activate the summer function. The fan will make air flow from the top
downwards, bringing cold air to the bottom of the room.
Warning:
Invert the spinning direction of the fan while in operation. Hold down the button for approx.
3 seconds: the appliance will beep, and the blades will start slowing down until they stop
spinning. After a few seconds, they will start spinning again in the opposite direction.
Natural breeze
Activate this mode by pressing button 5. The fan will run at different power levels in a cycle,
producing a feeling of fresh air.
Pairing the remote control with the fan
Press the power button for 5 seconds until you hear a beep.
Warnings:
- The remote control operates through RF Wireless digital transmission technology. If both
the fan and the lamp are equipped with a switch, turn on the fan at top speed and turn the
light on before using the remote control.
- If the fan or the light cannot be controlled through the remote control, check if the batteries
in the remote control are in good conditions and if they make good contact, that the positive
and negative electrodes are in the correct position, and if the batteries are charged.
- If the fan or the light cannot be controlled through the remote control, check if there are
other remote-controlled appliances in the same area and check if the transmitter buttons
are pressed. Appliances with similar remote-control systems may cause interference. This
does not include infrared remote controls.
- Pay attention to the appliance voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
- If the remote control is not going to be used for a long time, remove the batteries.
ENERGYSILENCE AERO 5290 NATURAL
ENGLISH
49