Idiomas disponibles
Idiomas disponibles
1. IMPORTANT SAFETY INSTRUCTIONS
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, PLEASE
ASSURE THAT:
The appliance is disconnected from the mains before any form of intervention.
The mains supply cabling and any extension cords are adequately sized, according to
the rated power of the pump and that there is no risk of the electrical connections
coming into contact with water.
Always use a Residual Current Device with IDn=30mA particularly in installations
pertaining to swimming pools, ponds or fountains.
CAUTION: When the pump stops, the system will still be under pressure, therefore, before any
intervention, make sure to open a tap to relieve the system.
The device should only be used for clean water systems and is not suitable for use with sea water,
sewage, drainage systems, explosive, corrosive or any other hazardous liquids.
2. WARRANTY
The manufacturer guarantees this product for a period of 24 months from the date of purchase; the
unit must be returned together with this instruction manual, clearly indicating the date of installation
on the last page. The warranty is automatically annulled if the appliance is subjected to any form of
unauthorized tampering, damage resulting from incorrect use and/or improper installation,
unsuitable environmental conditions or improper electrical installation.
The manufacturer declines any form of liability resulting from damages to buildings, personal
belongings and/or persons, caused by failure to install the necessary electrical protection devices
or inferior workmanship.
It is strongly recommended that the installation and maintenance of this appliance be undertaken
by qualified electricians, who are expected to fully understand the contents of this instruction
manual.The manufacturer cannot be held responsible for any kind of damage to people and/or
things ensuing from the failure of any internal safety devices to intervene, with the exception of
compensation for the device itself if still under guarantee.
3.TECHNICAL DATA
Power Supply: ... ... ... ... ... ... ... ... ... ... ... ................. .....................115-230VAC ± 10% 50/60 Hz
Max current: ... ... ... ... ... ... ... ... ... ... ... ... ... ......... ... ... ... ... ...... ...... ... ... ........ ..............10 A
Cut-in pressure range:....... ... ... ... ... ... .......... ... ... ... ... ... ... ....... ... ...................... .1 ÷ 3.5 Bar
Maximum allowed pressure: .....................................................................................10 Bar
Maximum water temperature: ......................................................................................50°C
Minimum ambient temperature: .....................................................................................5°C
Maximum ambient temperature: .... ..............................................................................50°C
Storage Temperature: ..................................................................................................-10÷50°C
Hydraulic connections: .. ................................................................................1" GAS male
Protection degree: ............. .....................................................................................IP 54
Type ( Ref. EN 60730-1 ):...............................................................................................1.C
Pollution degree: ..............................................................................................................III
Insulation category:........................................................................................................III
Ball Pressure Test: ........................................................................................................85°C
Recommended torque for cable clamps: .................................................................2,5÷3,0Nm
Recommended torque for hydraulic connections: ................................................max.8,0Nm
