12. Slide the canopy upwards so that all the connections are stored inside it and screw it to
the installation bracket using the 4 screws (2 to each side) removed at the beginning of
the installation process. Fig. 12
13. Remove the screws located on the lower part of the motor. Screw the blades to the
motor. Fig. 13A
14. Pass the light wires through the hole in the middle of the light kit. Attach the light kit to
the plate by tightening the screws. Fig. 13B
15. Install the lampshade in the lamp by turning it clockwise. Fig. 13C
Warning: the important safety precautions and instructions stated in this manual are not
meant to cover all possible conditions and situations that may occur. Bear in mind that
common sense and caution are necessary factors in the installation and operation of this fan.
4. OPERATION
Remote control
Fig. 14
WARNING: the remote control is properly synchronised with the fan when they leave the
factory, so once correctly installed they should work. If the remote control needs to be
replaced for any reason, it will need to be synchronised with the fan.
Synchronisation
To synchronise the fan:
1. Turn it on from the wall switch, you will hear a beep.
2. Immediately afterwards, press the light button (on/off) on the remote control, you will
hear a long beep, which means it is synchronised.
Legend Fig. 14
1. Receiver operation indicator light.
2. Buttons for switching on the fan at the desired speed. 6 speeds available to regulate the
intensity of the air flow.
3. Off button.
4. Reverse rotation button. A motor reversing system is available to provide the summer/
winter function. Rotating in one direction, you can enjoy a pleasant breeze in summer,
and, in the opposite direction, the fan will blow warm air to the floor and complement
your heating system in winter.
5. Breeze mode button. The 6 speeds will be randomly interchanged.
6. Light button. Light on/off to achieve the perfect atmosphere by selecting from the 3
available shades.
ENGLISH
ENERGYSILENCE AERO 3050
49