Idiomas disponibles
Idiomas disponibles
ENGLISH
Pairing the remote control with the fan: Press the power button for 5 seconds until you hear
a beep.
Warnings
-
The remote control operates through RF Wireless digital transmission technology. If both
the fan and the lamp are equipped with a switch, turn on the fan at top speed.
-
If the fan cannot be controlled through the remote control, check if the batteries in the
remote control are in good conditions and if the make good contact, that the positive and
negative electrodes are in the correct position, and if the batteries are charged.
-
If the fan cannot be controlled through the remote control, check if there are other remote-
controlled appliances in the same area and check if the transmitter buttons are pressed.
Appliances with similar remote-control systems may cause interference. This does not
include infrared remote controls.
-
Pay attention to the appliance voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
-
If the remote control is not going to be used for a long time, remove the batteries.
Changing the remote-control battery
The remote control requires 2 x 1.5 V-3 AAA batteries.
1.
Open the battery compartment.
2. Insert the batteries into the battery compartment observing the polarity.
3. Close the compartment.
5. CLEANING AND MAINTENANCE
-
Make sure to disconnect the fan before cleaning it.
-
Do not immerse any of the parts of the appliance in water or splash them with any other
liquid.
-
Do not use solvents or any other chemical products for cleaning.
-
Use a soft, damp cloth to clean the surface of the device.
6. TECHNICAL SPECIFICATIONS
Product reference: 08540
Product: EnergySilence Aero 7200 Pro
Voltage: 220 - 240 V
Frequency: 50 / 60 Hz
Power: 48 W DC - Max 50 W
48
ENERGYSILENCE AERO 7200 PRO
