• Seek advice from a person with special training in
dangerous materials before shipping the product
and comply with all applicable national regulations.
• Use tape on open contacts when packaging the
battery and ensure it is securely packed to prevent
movement.
• Remove the battery before storing or transporting
the product.
• Store the battery and battery charger in a dry,
moisture-free, and frost-free space.
• Avoid storing the battery in an area where static
electricity may occur, and do not store in a metal
box.
• Charge the battery 30% to 50% before long-term
storage.
• Store the battery charger in a closed and dry space.
• Keep the battery away from the battery charger
during storage, and ensure that unauthorized
persons, including children, do not touch the
equipment. Store the equipment in a lockable
space.
• Clean the product and perform full servicing before
long-term storage.
• Use transportation guards on the product to prevent
injury or damage during transportation and storage.
• Securely stow the product during transport to ensure
safe handling.
9.2
DISPOSAL OF THE BATTERY, BATTERY
CHARGER, AND PRODUCT
Symbols on the product or the package of the product
mean that the product is not domestic waste. Recycle
it at a recycling station for electrical and electronic
equipment. This helps to prevent damage to the
environment and persons.
Get in touch with your local authorities, domestic waste
service, or your dealer for more information about how
to recycle your product.
10
TROUBLESHOOTING
Problem
Possible
Cause
The prod-
Heavy cutting
uct stops
line is used.
when you
are cut-
The grass
ting.
winds around
the motor shaft
or the trimmer
head.
English
Solution
Use only with the ny-
lon cutting line of
1/8"(3.0mm)
diameter.
1. Stop the product.
2. Remove the bat-
tery.
3. Remove the grass
from the motor shaft
and trimmer head.
Problem
Possible
Cause
The motor is
overloaded.
The battery
pack or product
is too hot.
The battery
pack is discon-
nected from the
tool.
The battery
pack is deple-
ted.
The line
The product is
keeps
used incorrectly.
breaking.
The grass
Cut tall grass at
winds
ground level.
around
the trim-
mer head
and motor
housing.
The han-
The bolts are
dle is not
not installed
in posi-
correctly.
tion.
The prod-
The battery ca-
uct does
pacity is low.
not start.
The bail lever is
defective.
The prod-
The height is
uct cuts
not set correct-
grass un-
ly.
evenly.
11
Solution
1. Remove the trim-
mer head from the
grass.
2. The motor will re-
cover as soon as the
load is removed.
1. Allow the battery to
cool until its function
returns to normal.
2. Allow the product to
cool for approximately
10 minutes.
Reinstall the battery.
Charge the battery.
Cut with the tip of
the line, avoid stones,
walls and other hard
objects.
Cut tall grass from the
top down.
Adjust the height of
the handle and make
sure that the knobs
and bolts are aligned
correctly.
Charge the battery.
Replace the bail lever.
Adjust to a higher po-
sition.
EN
