WAGNER PROSPRAY 3.21 Instrucciones De Uso página 12

DESCRIPTION OF UNIT / STARTING OPERATION
3.5
TECHNICAL DATA
Voltage
Max. current consumption
Power Cord
Acceptance capacity
Max. operating pressure
Volume flow at 12 MPa (120 bar) with water
Max tip size
Max. temperature of the coating material
Max viscosity
Weight
Special high-pressure hose
DN 6 mm, 15 m, connection thread M 16
x 1.5
Dimensions (L X W X H)
Altitude
This equipment will operate correctly up
to 2000 m above mean sea level
Vibration
Spray gun does not exceed 2.5m/s
Max sound pressure level
* Place of measurement: 1 m distance from unit and
1.60m above floor, 12 MPa (120 bar) operating pressure,
reverberant floor
3.6
TRANSPORTATION IN VEHICLE
Secure the unit with a suitable fastening.
12
220~240 VAC, 50/60 Hz
4.5 A
3 x 1.5 mm – 6 m
2
1035 Watt
221 bar (22.1 MPa)
2.0 l/min
0.023 inch – 0.58 mm
43°C
20.000 MPa·s
17.9 kg
437 x 363 x 416 mm
80 dB*
4
STARTING OPERATION
4.1
HIGH-PRESSURE HOSE, SPRAY GUN AND
SEPARATING OIL
1. Screw the pressure gauge (1) to the coating material
outlet (Fig. 2, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet (Fig. 2, Item 4).
3. Screw the spray gun (5) with the selected tip onto the
high-pressure hose.
4. Tighten the union nuts at the high-pressure hoses firmly
so that coating material does not leak.
1
4
5. Remove the oil cup cap with a straight-slot screwdriver.
6. Fill the oil cup with EasyGlide (Fig. 3) until the oil gauge (6)
2
is showing that it is full.
EasyGlide prevents increased wear and tear to
the packings.
Attention
7. Replace oil cup cap.
8. Press oil button 2-5 times to prime the oiler. Press once for
every eight hours of usage to lubricate the fluid section.
9. Fully depress the pusher stem to make sure the inlet ball is
free.
2
3
PS 3.21
5