Idiomas disponibles
Idiomas disponibles
USE
Switch off the device after you
fi nish cleaning each surface to
signifi cantly increase the operating
time on each battery charge.
1. Tilt the stem mount (5) on the main
unit (A) back a little using the handle
(C) in order to trigger the release mech-
anism and activate the device. The
LEDs (10) switch on and the battery
status display (7) lights up.
2. Press the On / Off switch (1) on the
handle to switch on the device. The
two cleaning feet (8) start to vibrate.
3. Guide the device over the surface to be
cleaned or polished.
4. If necessary, press the spray trigger (1)
on the handle to wet the fl oor with the
aid of the spray nozzle (9).
5. To switch off the device, press the
On / Off switch on the handle again.
The cleaning feet stop vibrating.
6. Tilt the stem mount on the main unit
upwards using the handle in order to
trigger the release mechanism and de-
activate the device. You must feel the
stem engage. The LEDs switch off and
the battery status display goes out.
CLEANING AND STORAGE
Please Note!
■ During cleaning make sure that no liq-
uid gets into the main unit (apart from
the water tank) or the handle.
■ Do not use any sharp or abrasive clean-
ing agents to clean the housing. They
may damage the surfaces.
The mop pads may lose some
of their colour over time. This is
normal and does not have any ad-
16
verse effect on function. However,
if one of the mop pads is damaged
or worn, it must be replaced.
○ If there is still water in the water tank,
empty it.
○ Clean the device with a damp, soft
cloth if necessary. Then dry with a soft
cloth.
○ Pull the mop pads (F) off the clean-
ing feet (8) and clean them. Note the
washing label when you do this! Please
Note: Wash separately or with similar
colours. Do not use fabric softener.
○ Charge up the battery after every use
(see the "Charging Up the Battery"
chapter).
○ Store the device and the accessories
in a dry place which is protected from
sunlight and is out of the reach of
children and animals.
TROUBLESHOOTING
If the device does not work properly, check
whether you are able to rectify the problem
yourself. If the problem cannot be solved
with the steps listed, contact the customer
service department.
Do not attempt to repair an electri-
cal device yourself!
The battery is not charging. The bat-
tery status display (7) does not light
up when the device is connected to
the mains power.
The mains adapter is not inserted in the
plug socket correctly.
► Correct the fit of the mains adapter.
The barrel connector is not plugged
correctly in the charging socket (6) of the
main unit (A).
► Correct the connection between the
charging socket and barrel connector.
The plug socket is defective.
