Idiomas disponibles
Idiomas disponibles
device in order to achieve the maxi-
mum charging capacity.
1. Fold the stem mount (5) on the main
unit (A) upwards. It must be upright
so that the device is deactivated and
cannot be switched on accidentally.
2. Open the protective cover for the
charging socket (6) on the main unit
and connect the barrel connector of
the mains adapter (B) to the charging
socket.
3. Connect the mains adapter to a plug
socket. The battery status display (7)
fl ashes (• 30%, •• 65%, ••• 100% charge).
The battery is fully charged up when
the battery status display is constantly
lit.
4. Disconnect the mains adapter from the
mains power and then from the main
unit.
5. Close the protective cover for the
charging socket again.
The battery status display lights up
red when the battery is empty.
REPLACING THE BATTERY
IN THE HANDLE
The handle (C) is equipped with a 3 V bat-
tery, CR2032 (already inserted on delivery)
and communicates with the main unit
wirelessly. The battery compartment is lo-
cated in the handle. If the device cannot be
switched on even though the battery of the
main unit (A) is fully charged, the battery in
the handle may need to be replaced. To do
this, proceed as follows:
1. Remove the white covers using a
pointed object.
2. Remove the screws in the handle with
a screwdriver.
3. Carefully take apart the handle.
4. Remove the used battery and insert a
new 3 V battery of the CR2032 type.
The positive pole must be facing
upwards.
Before inserting the battery, check
whether the contacts in the handle and
on the battery are clean, and clean them
if necessary.
5. Place both parts of the handle together
again. If necessary, make sure that
the spring rests on the bottom black
button.
6. Insert the screws and screw them so
they are handtight.
7. Place the covers into the holes.
FILLING THE WATER TANK
Please Note!
■ When the water tank is fi lled, the main
unit must not be tilted, turned upside
down or laid or placed on its side.
Water could leak out!
1. Fold the stem mount (5) on the main
unit (A) upwards. It must be upright
so that the device is deactivated and
cannot be switched on accidentally.
2. Open the water tank cap (11) on the
main unit.
3. Fill the water tank with water (max.
280 ml) using the measuring cup (E)
(Picture D).
4. Close the water tank cap.
EN
15
