Idiomas disponibles
Idiomas disponibles
Mount the cabinet and aquarium according to the attached instructions.
Always re-tighten all bushings before use. The rubber slide ring must always be attached to the side of the
rotable nut, the rubber gasket on the opposite side of the panel.
Before setting up the aquarium, please make sure that the load-bearing capacity of the base is sufficient for the
filled system as a whole. The floor must be firm and level. It must not give under pressure.
The contact surface between the glass base and the surface of the base cabinet must be free of any kind of
dirt. The use of a mat between the glass base and base cabinet is expressly not recommended.
To avoid condensation, it is important that the room where the aquarium is put up is well-tempered.
A space of at least ten centimeters should be left on the back of the cabinet and aquarium for
ventilation and for laying cables with plugs.
Fig. 3: Bushing or tank fitting (the glass pane is placed between slide ring 3 and rubber ring 2)
1.
Thread
2.
Rubber sealing
3.
Slide ring
4.
Nut
Fig. 4: Overflow with sponge and cover
When starting the aquarium, water has to be filled in until the filter tank in the compartment for the circulation
pump is filled up to 15 cm and then the pump (not included) has to be started. If the water level in the filter
tank drops, fill with water until the pump no longer sucks in air. Take care that sufficient space is left in the filter
tank so that any water that flows in when the pump fails or shuts off will still fit into the filter tank.
8
