SOMFY Sonesse 30 RS485 Manual De Instrucciones página 11

Sonesse 30 RS485
3.USE AND MAINTENANCE
NOTICE
This drive does not require any maintenance operations.
CAUTION
• For the safety of goods and people, Somfy drives are equipped with thermal
protection that will trigger the drive stops in the event of overheating.
• Repeated activation of this protection can degrade drive performance.
• If the drive goes to thermal protection, please check your installation and
check that the drive is rated for the intended use.
• A normal installation is not expected to trigger this protection.
NOTICE
When some functions require a power cut, the power cut is only taken into
account if it lasts more than 10 seconds.
3.1.Operation
To control the drive, please refer to the installation instructions of the used control
point.
3.2.PROG button
In user mode, control drive UP / Stop /
Down / Stop
Post node ID on the network
Reset drive to factory
3.3.LED feedback
LED colors
Green lights fixed ON for 2 seconds at
Power ON.
blinks 5 times.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
Short press (< 1,5 s)
Press until first feedback (about 2 s)
Press until third feedback (about 12 s)
Feedbacks Possible causes
Power is ON.
Validation setting is done.
EN
11