Seat Pan - Ki Mobility FOCUS CR Manual De Instrucciones

V. SET UP & USE OF YOUR WHEELCHAIR
W. Seat Pan
1. Removal
a. Using a 5mm Allen wrench, remove button head
screws (Fig. 49:A) from corners of seat pan.
b. Remove seat pan assembly (Fig. 49:B), seat pan
brackets (Fig. 49:C), seat pan clamps (Fig. 49:D)
and nuts (Fig. 49:E) from seat tubes.
2. Installation
a. Set seat pan onto seat frame.
b. Slide one seat pan bracket (Fig. 49:C) onto seat
tube and link seat pan clamp (Fig. 49:D) onto
bracket, wrapping around seat tube. Hold nut
(Fig. 49:E) in slot of clamp as shown and thread
button head screw (Fig. 49:A) through seat pan
into clamp. Do not tighten. Repeat for all four cor-
ners of seat pan.
c. Adjust seat pan in so it is square to the chair and in the desired position, with the front edge
of the seat pan approximately 3/8" behind vertical footrest hanger tube.
d. Tighten all four button head screws using a 5mm Allen wrench when proper position is
obtained.
3. Length Adjustment
a. Using a 5mm Allen wrench and a 13mm wrench, remove all four button head screws (Fig.
49:F) from center area of seat pan.
b. With 5mm Allen wrench, loosen all four button head screws (Fig. 49:A) from seat pan
clamps (Fig. 49:C).
c. Slide seat pans forward or rearward, aligning proper holes to achieve desired seat pan
length.
d. Reinstall and tighten button head screws (Fig. 49:F) with nuts.
e. Reposition seat pan on seat frame as necessary and tighten button head screws (Fig. 49:A)
in clamps.
4. Width Adjustment
NOTE: Seat pan width may be adjusted up to 2" wider for even widths or 1" wider for odd
widths. For greater adjustment than this, new seat pans must be obtained. Contact Ki Mobility
Customer Service.
a. Remove seat pan (See step 1 above) and adjust width of chair to desired width (See Section
U).
b. Align seat pan clamp holes with desired set of holes in seat pan to achieve larger frame
width.
c. Reinstall and tighten button head screws and nuts through seat pan clamps (See step 2
above).
A
B
C
D
E
43
F
Fig. 49