Ki Mobility FOCUS CR Manual De Instrucciones página 19

V. SET UP & USE OF YOUR WHEELCHAIR
C. Height Adjustable T-Arms
4. Adjusting Position
a. Remove both screws (Fig. 3:A) from each armrest receiver (Fig. 3:B) retaining the spacers
(Fig. 3:C) if installed. If not installed at factory, they are included in a separate bag in the
packaging.
b. Move receiver to desired location on seat frame and reinstall screws with washers and nuts
and tighten.
c. If screws for new armrest receiver location coincide with seat frame screws (Fig. 3:D and E),
remove seat frame screws and replace with armrest receiver screws. Retain (do not discard)
these screws for potential future use, or optionally, they may be retained by reinstalling them
in an alternate location on the seat frame.
d. If one of the armrest receiver screws lies on the center growth section of the seat frame, be
sure to use the spacers (as described in step 1) around growth tube in location of mounting
hole.
DANGER: Failure to comply with the instructions above may result in the armrest accidently
disconnecting from the wheelchair and result in a fall or loss of control and may cause serious
injury or death.
DANGER: Never attempt to lift the chair by the armrests; they may break or disconnect resulting
in a fall or loss of control and may cause serious injury or death.
Fig. 3
D
C
B
A
18
E