Cinderella Travel Manual Del Propietário página 6

HOW THE TOILET WORKS
When the toilet visit is over, the bowl liner with its contents is released into the incineration chamber.
High heat and air are added causing the liquid to evaporate and the remaining waste is burnt and
turned into ash. Residual heat and fumes are emitted via the exhaust pipe. A catalytic converter
prevents unpleasant odours.
USE (OPERATION)
BEFORE USE
1. Make sure the power supply is connected.
2. Make sure the propane is connected.
3. Use only propane / LPG.
USING THE TOILET
1. Lift up the lid and the seat. The red light flashes and the green light is illuminated. The exhaust fan
will start automatically.
2. Place the bowl liner inside the bowl, ensuring that the liner's seam is in line with the "seam" of the
bowl. Remember to use a new bowl liner for each visit (Illustration 1).
3. Put the seat down. The toilet is ready for use (Illustration 2).
4. Use the toilet. For small amounts of waste, add a cup of water to make the liner heavy enough to
slide down into the incineration chamber.
5. Close the toilet lid.
6. Press the start button (Illustration 3). When the hatch closes, the incineration begins. The toilet is
then ready for use again.
7. A yellow light on the control panel indicates that incineration is in progress. The light will illuminate
throughout the duration of the incineration process.
Illustration 1
GENERAL INFORMATION ABOUT THE USE OF CINDERELLA TRAVEL
Make sure the ash container is in the correct position.
1. Always place a bowl liner in the bowl before use.
The toilet lid must always be closed when the toilet is not in use.
2. Incineration cannot commence until the lid is down in closed position.
3. If the lid is opened, any active incineration will stop. The toilet is then ready for use. After each
visit, the incineration is re-started by pressing the start button on the control panel. The toilet will
automatically detect when the incineration has finished.
4. The yellow light on the control panel switches off when the incineration ends. The fan stops when
the temperature in the incineration chamber has cooled down sufficiently (1–1.5 hours after
incineration ends).
6
Illustration 2 Illustration 3