Setting Up The Device; Connecting The Device; Filling The Water Tank; Switching The Device On/Off - Silvercrest STLKS 12 A1 Instrucciones De Servicio

5.2

Setting up the device

• Place the desktop air cooler 10 on a flat
surface where the device is secure and
cannot be accidentally knocked over.
• Choose a place...
... with sufficient clearance around the
device 10.
... at table height (e.g. on a desk or
chest of drawers) for optimum air cir-
culation.
... near the place you want cooled.
NOTE: When selecting the location, please
note that the connected device will remind
you via acoustic signals to change the water
after up to 72 hours. These acoustic signals
occur regardless of the time of day.
5.3

Connecting the device

1. Plug the power supply unit 7 into a
properly installed, easily accessible
mains socket whose voltage corre-
sponds to that specified on the rating
plate. The wall socket must still be easi-
ly accessible after connection.
2. Insert the jack plug 8 into the jack sock-
et 9 on the back of the device 10.
The LED 4 flashes red and several acoustic
signals sound. This is a reminder that the wa-
ter tank 13 must be cleaned at least every
72 hours and filled with fresh tap water be-
fore each use. When you reinsert the water
tank afterwards, the LED stops flashing.
5.4

Filling the water tank

If you want to use the misting function
Mist 21, fill water into the water
tank 13.
You can also use the device 10 without wa-
ter. It then operates as a fan without the de-
scribed cooling effect.
24 GB
1. Pull the water tank 13 out of the de-
vice 10.
2. Remove the lid 15 from the water
tank 13.
3. Fill the water tank 13 no higher than
the MAX marking (450 ml) next to the
viewing window 12. Use cold, fresh
tap water without additives.
NOTE: to increase the cooling effect, you can
cool the tap water in the refrigerator before-
hand.
Figure B: the water tank 13 can also be
filled with ice cubes in the outer section - for
better cooling.
4. Put the lid 15 back on the water
tank 13.
5. Dry the outside of the water tank 13.
6. Push the water tank 13 back into the
device 10. It clicks audibly.
Filling the water tank 13 to the MAX mark-
ing is sufficient for approx. 6 hours of oper-
ation with the misting function
When the water is used up, the device re-
minds you to refill it by the LED 4 flashing
red and sounding an acoustic signal. The
device continues to run without the misting
function.
5.5 Switching the device on/
off
• Press the on/off switch
for approx. 1 second to switch the de-
vice 10 on.
- An acoustic signal sounds.
- The fan starts at a low speed. The 1
on the display 17 lights up.
• Press the on/off switch
again for approx. 1 second to switch the
device 10 off again. An acoustic signal
sounds.
• After each use, unplug the power supply
unit 7, and empty and clean the water
tank 13 if necessary.
Mist 21.
Power 18
Power 18