Idiomas disponibles
Idiomas disponibles
source and wait for the machine
to come to a standstill. Discon-
nect the machine from the mains
supply or remove the batteries
and perform the following steps
before re-starting and operating
the machine:
- investigate for damage;
- replace or repair damaged
parts;
- check for loose parts and
tighten as necessary.
• Ensure that you do not touch any
of the dangerous moving parts
before you have unplugged the
machine from the mains supply
or removed the batteries from
the machine, and that the dan-
gerous moving parts have come
to a complete standstill.
• In the case of an accident
or malfunction during op-
eration, the device must be
switched off immediately.
Injuries must be properly
treated or medical assis-
tance sought. Read the "Trou-
bleshooting" section to correct
any malfunctions or contact our
Service Centre.
Maintenance and storage:
• Regularly check the functional-
ity and integrity of the device to
avoid danger to the operator.
• Replace worn or damaged parts
in the interests of safety. Only
use original replacement parts
and accessories.
• Do not try to repair the device
yourself, unless you have profes-
sional training. All work not men-
tioned in these instructions may
only be performed by authorised
service representatives commis-
sioned by us.
• Store the device in a dry place
and out of reach of children.
• Treat your device with care.
Clean the ventilation slits regu-
larly and follow the maintenance
instructions.
• Keep all inlets for the cooling air
free of debris.
• Do not use the device if the
switch cannot be turned on and
off. Damaged switches must be
replaced at a customer service
workshop. Do not overload your
device. Only work within the
power range indicated. Do not
use low-performance machines
for heavy work. Do not use the
device for purposes for which it
is not intended.
• If you stop the machine for main-
tenance, inspection, storage or
to change accessories, switch off
the power source, disconnect the
machine from the mains supply
or remove the batteries, and en-
sure that all moving parts have
come to a standstill. Allow the
machine to cool down before in-
spection, changing settings etc.
Maintain the machine with care
and keep it clean.
• Always allow the machine to
cool down before storage.
• Never try to circumvent the lock-
ing function of the protective
equipment.
GB
IE
25
