Dry Ironing; Steam Ironing - Oster GCSTTS7010 Manual De Instrucciones

To select a fabric setting, turn the Fabric Select Dial/Press the "
GCSTTS7014 only) to the desired fabric selection. The wait light will glow red while the
iron heats up. The light will then change to green indicating that the iron is ready to be
used.
1. Make sure the Steam Dial/Buttons (for model GCSTTS7014
only) is turned to the closed position "
2. Plug the cord into the appropriate outlet.
3. Turn the Fabric Select Dial/Buttons (for model GCSTTS7014
only) to the fabric setting you desire (Silk "Seda" or Synthetics
"Sintet").
Allow the iron to heat for 2 minutes. While the iron is heating,
make sure it is sitting on its heel rest on a stable, protected
surface.
NOTE: While the Steam Dial/Button (for model GCSTTS7014 only)
is turned to the closed position "
Steam or Spray Mist features. Please make sure the water reservoir
is 1/4 full of water.
TIP: Refer to the "Ironing Guide" for the recommended setting for
your fabric.
1. Follow the instructions for "Filling With Water".
2. Plug the cord into the outlet. The power indicator light will
illuminate.
3. Turn the Fabric Select Dial/Buttons (for model GCSTTS7014
only) to the steam ironing fabric setting you desire (Linen "Lin",
Cotton "Algod", Wool "Lana" or Silk "Seda") and allow iron to heat
for 2 minutes. While the iron is heating, make sure it is sitting on
its heel rest on a stable, protected surface.
TIP: Refer to the "Ironing Guide" for the recommended setting for
your fabric.
4. After the iron has heated (2 minutes), turn the steam dial/button
(for model GCSTTS7014) to the desired steam setting.
IMPORTANT: When not ironing, always set the Steam Dial/Buttons (for model
GCSTTS7014 only) to closed position "
GCSTTS7014 only) to off position "O".
SELECTING FABRIC SETTINGS

Dry Ironing

".
", you may still use the Shot of

Steam Ironing

" and the Fabric Select Dial/Buttons (for model
English - 5
" Buttons (for model
Model GCSTTS7014
Model GCSTTS7014