PROMEBA PS-251 Manual De Instrucciones página 94

USER GUIDE
CHAIR PS-251 + PA-260
07
GENERAL MAINTENANCE
07.1. Cleaning
It is essential to keep the equipment clean to ensure proper use and durability of the set.
Thorough cleaning should be carried out periodically, especially in areas exposed to dirt that
can accumulate dirt such as corners or holes.
Do not use high pressure cleaning systems or bleach to disinfect the product, they can
damage it. Instead, use a hydroalcoholic-based disinfectant, wash it with water and let it dry
naturally, do not use direct heat sources to dry.
Non-compliance with cleaning operations can lead to the risk of cross infections due to the
presence of secretions and/or residues. During all control and disinfection operations, the
operator must wear appropriate personal protective equipment, such as gloves, glasses, etc.
When the cleaning procedure includes a disinfectant product, carefully follow the instructions
of the manufacturer of the product used regarding the method of application and contact time.
Make sure that you have taken all the necessary precautions to ensure that there are no risks
of cross-infection or contamination of patients and operators.
Failure to carry out the correct cleaning routine could increase the risk of cross infection, due to
presence of body fluids and/or residuals.
The operator must always wear adequate personal protection such as gloves and mask, etc. during all
checking and cleaning procedures.
Be sure to keep these zones free of dirt.
Have special care in the cleaning to ensure good functioning of the set
07.2. Lubricating
In general, all moving parts must be greased. Our products leave the factory completely
greased and lubricated, however, it is possible that over time and use of the product the
elements become degreased, either due to loss of lubrication or due to dirt.
Periodically clean and oil affected areas according to manufacturer's specifications. Check
for loose, missing or worn parts.
Never lubricate the belts. Lubrication can cause the belts to perform unpredictably, which can
cause injury to the patient and/or operators.
07.3. Wear areas
Periodic inspection of the different components of the system for signs of wear is a
preventative measure that can reduce breakdowns. Check possible lubricant leakages,
EN
REV. 2023/11
94