Idiomas disponibles
Idiomas disponibles
545150014
Pilot won't stay lit
Burner won't light
Burner flame is low
Note: Do not operate the
appliance
below
(40°F)
Emitter glows uneven
Note: Bottom 2.5cm of
emitter normally does not
normally glow
Carbon build-up
Thick black smoke
Igniter fails
Dirt build up around pilot
Connection between gas valve an
d pilot assembly is loose
Bad thermocouple
Gas pressure is low
Blockage in orifice
Control knob is not in "ON" positio
n
Gas pressure is low
℃(40°F)
Outdoor temperature is below 5
and tank is less than 25% full
℃
Supply hose is bent or kinked
5
Control knob is fully " ON"
Gas pressure is low
Base is not on a level surface
The appliance is not level
Dirt or film on reflector and emitt
er
Blockage in burner
Use match to light pilot, and
obtain new
igniter and replace.
Clean dirt from around pilot
Tighten connection and perf
orm leak test
Replace thermocouple
Replace gas cylinder
Clear blockage
Turn control knob to "ON" p
osition
Replace gas cylinder
Replace gas cylinder
Straighten hose and perform
leak test on hose
Turn control knob to "OFF", l
et it
room temperature and chec
k burner and
orifices for blockage
Replace gas cylinder
Place the
appliance on a level surface
Level the appliance
Clean reflector and emitter
Turn control knob to "OFF", l
et
it cool to
room temperature and remo
ve
blockage and clean burner in
side and outside.
EN
cool to
13
