Idiomas disponibles
Idiomas disponibles
545150014
The life expectancy of the regulator is estimated as 10 years. It is recommended that the
•
regulator is changed within 10 years of the manufacturing date or earlier if local regulations
require it.
The replaceable hose should meet the standard of EN16436-1.
•
The length of the hose must be 0.4 meters (minimum) and 1.0 meters (maximum). A worn or
•
damaged hose must be replaced. Ensure that the hose is not obstructed nor kinked. It is
recommended that the hose is changed within 1 year of the manufacturing date or earlier if
local regulations require it.
Never use a gas cylinder with a damaged body, valve, collar, or foot ring. A dented or rusty gas
•
cylinder may be hazardous and should be checked out by a gas supplier.
Always perform a leak test on gas connections whenever a cylinder is connected. If bubbles
•
form in the leak test solution, do not use the appliance. Never use a flame to test for leaks.
Never connect the appliance to an unregulated gas source.
•
Use only regulator and hose approved for LP Gas at the correct pressures and gas type.
•
Using 30mbar propane regulator for propane or butane/propane mixture of I3B/P(30).
•
Using 37mbar propane regulator for propane of I3P(37).
•
CONNECTING A GAS CYLINDER
Gas cylinder maximum: 13 kg.
•
Refer to your gas supplier for instructions on the use of your gas cylinder.
•
Only change gas cylinders outdoors or in a well ventilated area away from naked flames and
•
any other source of ignition.
The gas cylinder must always be used in an upright position.
•
Close the appliance control knob by turning fully clockwise.
•
Close the gas cylinder tap and then attach the regulator onto the gas cylinder.
•
Tighten all connections firmly and with a spanner where appropriate.
•
The cylinder should be located on the cylinder base.
•
Check for leaks at all joints using soapy water. If a leak is found, tighten the joint and then re-
•
test.
EN
7
