Idiomas disponibles
Idiomas disponibles
INSTALLING THE GAS HOB
Very important!
The installation of the gas hob must be carried out only by an authorized
installer. MX ONDA will not accept any responsibility and the guarantee will
be invalid in the event of an erroneous or incorrect installation.
The following instructions are addressed to the authorized installer, the
installation and maintenance must always be carried out by qualified personnel
and/or authorized technicians.
Warning: Unplug the gas hob from the electrical outlet before carrying
out any maintenance work.
Room ventilation
This gas hob must be installed and used in rooms with permanent ventilation
and adequate to current regulations. The following requirements must be
considered:
a) The room must be prepared with a ventilation system that facilitates the
exit of smoke and combustion gases to the outside. In specific cases it is
possible to resort to electric hoods or extractors to force ventilation.
b) The air intake hole for ventilation must be large enough to allow an air flow
of at least 2 m³/h per kW of installed heat capacity.
The outside air intake duct for ventilation must have a minimum of 100 cm²
and must not be easily blocked or obstructed.
Gas equipment without safety devices must have a vent twice the volume
of equipment with protection. For example, a minimum of 200 cm² (Fig.3),
another option (less advisable) would be to use an adjacent room with a
ventilation inlet (Fig.4). In this case, the door must have enough clearance
at the bottom to allow ventilation, even if it is closed.
Through an extractor
9
Directly outside
.
