Polar UA037 Manual De Instrucciones página 7

Automatic Cleaning Function
This Ice Maker is featured with an automatic
cleaning function. When the appliance has
completed up to 1500 ice-making cycles (roughly
after 3-month routine use), the "CLEAN" indicator
light will flash with audible alarm, indicating the
unit needs to be cleaned. It will keep flashing and
alarming until auto-cleaning is started, during
which ice can still be made.
1. Press and hold the "CLEAN" button for
3 seconds. The "CLEAN" indicator light will
stop flashing and illuminate. The water box at
the top will turn down and up. When it returns
to vertical position, press the power switch
to O (OFF position) and unplug the machine.
Make sure no water remains in the water box.
Power switch
2. Unscrew the drainage valve cap at the right
lower part at the rear. Let the water drain from
the water reservoir thoroughly. Afterwards, re-
locate the drainage cap and screw tight.
UA037_ML_A5_V1_20240118.indb 7 UA037_ML_A5_V1_20240118.indb 7
CLEAN indicator light
CLEAN button
Drainage valve
cap
Model: UA037
3. Add dilute cleaner into the reservoir (about
3L). Note: Choose ice maker specific cleaner
and follow the manufacturer's instructions.
4. Plug the unit and press the power switch to I
(ON position). The "CLEAN" indicator light will
flash again.
5. Press and hold the "CLEAN" button for
3 seconds. The "CLEAN" indicator light will
stop flashing and illuminate. The cleaner in the
water reservoir will be pumped into the water
box to start cleaning. After about 10 minutes,
the water box turns to vertical to drop the
cleaner. The appliance will repeat the above
procedure two further times.
6. Turn the unit off and unplug. Remove the
drainage valve cap to empty the water
reservoir. When the unit is turned on again,
the "CLEAN" indicator light will not light up
or flash, indicating the whole auto-cleaning
is completed. Note: A cycle takes about
30 minutes.
Note: If the "WATER LOW" indicator light
illuminate during cleaning, it means the water box
is in lack of water and cleaning fails. In this case,
turn the unit off. After the WATER LOW" indicator
light goes out, turn the unit on again. Then fill the
reservoir with cleaner and repeat step 5.
Note: After auto-cleaning, use the first 3 ice
making cycles to flush out the system. Discard the
water and ice created from these initial cycles.
Notes for Descaling:
• In hard water areas lime scale can build up
within the appliance after prolonged use. We
suggest installing a water softener before inlet
of water in case the supplied water is hard.
The softener could be a mechanical filter.
• To descale, always choose a suitable descaler
and follow the manufacturer's instructions.
• POLAR recommend that this appliance is
descaled every 3 months or more frequently in
hard water areas.
EN
Reservoir
7
2024/1/18 14:38 2024/1/18 14:38