Panasonic EY7880 Manual De Instrucciones página 7

24) NOTE: If the supply cord of this appli-
ance is damaged, it must only be re-
placed by a repair shop appointed by
the manufacturer, because special
purpose tools are required.
25) TO REDUCE THE RISK OF ELEC-
TRIC SHOCK, THIS APPLIANCE
HAS A POLARIZED PLUG (ONE
BLADE IS WIDER THAN THE
OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
WARNING:
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the use
of the recycled battery pack and the
counterfeit battery pack.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not drive the likes of nails into the
battery pack, subject it to shocks, dis-
mantle it, or attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack in
the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as
next to a fire or in direct sunlight. Other-
wise, the battery may overheat, catch
fire, or explode.
• Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak, over-
heat, or explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fire.
• When the Battery Pack Has Deteriorat-
ed, Replace It with a New One.
Continued use of a damaged battery
pack may result in heat generation, ig-
nition or battery rupture.
. ASSEMBLY
Attaching or Removing Bit
Chuck
NOTE: Grease for bit
Grease the oval indentation
on the bit with the supplied
grease at least once a month.
1. To mount the bit
1-1. Insert a bit into the mounting hole,
and turn it slightly to locate an en-
gaged position.
1-2. At the engaged position, push the
bit as far as it goes. Make sure that
the bit is fixed by pulling it.
2. To dismount the bit
2-1. Depress the chuck cover and pull
the bit.
Attaching or Removing Bat­
tery pack
Battery holder
The battery pack is designed to be in-
stalled by proceeding two steps for safety.
Make sure the battery pack is installed
properly to the main body before use.
Battery pack Installation and Removal
-For removal-
Push the battery holder (
- 7 -
SDS PLUS type
shank
).