ADURO H1 Manual De Usuario página 60

3.3.2 Lighting the fire manually with firewood
The fire lighting method is very important for starting combustion quickly and efficient.
1. Pull the damper under the door fully out so that primary, secondary, and tertiary air supply is
completely open.
2. Place a log of wood crosswise in the combustion chamber and put 2 firelighters close to the log.
Light the firelighters and quickly put a new log close to the firelighters and several small logs at an
angle above it. Air must be able to reach the firelighters, but the logs should be touching to "warm"
each other.
3. Keep the door approx. 1 cm ajar, until the glass is too hot to touch. Then close the door. When there
are distinct, visible flames and the fire has taken hold, close the primary air intake.
The control handle will get warm when the Aduro H1 is in use. Please use the
glove provided when you operate the Aduro H1.
3.3.3 How do I add pellets?
Place the enclosed funnel in the opening of the pellet box and add the pellets. The pellets are distributed
with a poker in the box to make use of the entire capacity (approx. 15 kg of pellets).
By the first use, the augers must be filled with pellets:
Open the door to the combustion chamber and lift out the front of the
burning cave (the black cast iron cone with the Aduro logo) so you can
see the pellets. Close the stove's door. Press and hold the AUGER
button and the augers will start transporting the pellets (only at OFF mode
yellow button). After approx. 12 minutes where you press and hold the
AUGER button, the auger pipe will be filled with pellets. Stop pressing the
AUGER button when the pellets are about 2 cm under the auger pipe's
top edge. Insert the burning cave and close the stove's door. In section 5
you will find an overview of the different alarms.
Burning cave
60