Norwood LumberMax HD38 Instrucciones Originales página 14

Install the loader cradle sub-assembly
onto the mounting bracket (item #17)
using the 1/2" x 4 pin (item #19). Secure
the pin with the provided hairpin.
Slide the female connector bar (item
#13) into the loader arm (item #15)
located at the back of the sawmill. Then,
insert the male connector bar (item #14)
into the other loader arm (item #15) and
into the female connector bar (item #13),
secure bar using 3/8" x 1" bolt (item #1).
Center the bar sub-assembly and tighten
the 3/8" x 1" bolts (item #1).
The mounting brackets (item #17) is
meant to attach the cradle (item #16)
and loader arm (item #15) to the sawmill
bed.
NOTE: It is not designed to hold the
weight of the log, so it's necessary
to firmly support the cradle on the
ground. If the ground is uneven
and/or soft, use whatever planks or
similar necessary to support them
properly.
EN–6