Idiomas disponibles
Idiomas disponibles
The best result is achieved if you do not operate the
product directly on the base, but slightly away from the
base and at a flat angle if possible.
1. Raise the product by the handle (2).
2. To switch on the product, slide the on/off switch (1)
to position "1".
3. Swivel the product to the left and right.
4. Adjust the air speed during work to the material to
be blown away. To increase the air speed, slide the
on/off switch (1) to position "2".
5. To switch off the product, slide the on/off switch (1)
to position "0".
9.3
Overload switch-off
In the event of overloading, the motor will switch itself
off. After a cool-down period (time varies) the motor can
be switched back on again.
10 Working instructions
• Point the air jet forward and move slowly to blow
leaves or garden waste together or remove them
from hard-to-reach places.
• Some noise pollution from this product is unavoid-
able. Postpone noisy work to approved and desig-
nated times. If necessary, adhere to rest periods.
11 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always perform
maintenance and cleaning work with the
battery removed. There is a danger of inju-
ry! Let the Product cool down before all
maintenance and cleaning tasks. Elements
of the engine are hot. There is a danger of
injury and burning!
The product can start unexpectedly and cause inju-
ries.
–
Remove the battery.
–
Allow the product to cool down.
–
Remove the tool attachment.
11.1
Cleaning
1. Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure. We recommend
that you clean the product directly after every use.
2. Ventilation openings must always be free.
3. Do not use any cleaning products or solvents; they
could attack the plastic parts of the product. Make
sure that no water can penetrate the product interi-
or.
11.2
Maintenance
The product is maintenance-free.
12 Storage
Preparation for storage
1. Remove the battery.
2. Clean and check the product for damage.
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
13 Repair & ordering spare parts
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
ATTENTION
According to the German Product Liability Act, no lia-
bility is accepted for damage caused by improper re-
pairs or by not using original spare parts.
Such work should be performed by a customer ser-
vice centre or an authorised specialists. The same
applies to accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
13.1
Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Battery GO-ABP 2.0 item
no.:
www.scheppach.com
7909201714
GB | 23
