Idiomas disponibles
Idiomas disponibles
MAINTAINING YOUR 2-IN-1 CLEANER
5. After cleaning the dirty water tank and the solids
separator, allow them to air-dry in a well-ventilated
area for at least 24 hours. To reinstall the tank, insert
the bottom into the opening in the main body, then
tilt the tank back until it clicks into place.
CHECKING FOR BLOCKAGES
If you run over a hard or sharp object or notice a noise change while using your unit, check for blockages or
objects caught in the brushroll, nozzle chamber, or inlet hose.
s h a r kc l e a n . e u
5
1. Turn off the power.
2. Remove the brushroll cover, brushroll, and dirty
water tank.
3. Check the openings and remove all debris.
4. When finished, reinstall the brushroll and the cover.
MAINTAINING YOUR 2-IN-1 CLEANER
TROUBLESHOOTING
WARNING: To reduce the risk of shock and unintended operation, turn off power before servicing.
LED INDICATOR
WHAT IT MEANS
The Water Droplet LED is
pulsing red.
The dirty water tank is full.
The Water Droplet LED is
The clean solution tank is
pulsing aqua.
empty.
The Area Rug icon and
the three water droplet
lights are flashing red at
Brushroll cover is not
the same time.
installed properly.
The Area Rug icon and
the three water droplet
lights are flashing red out
of sync.
The brushroll is jammed.
NOTE: If 2-in-1 Cleaner still does not operate properly, contact Customer Service at 1 800 798 7398 or
sharkclean.com/support
WHAT TO DO
Empty the fluid in the dirty
water tank. Refer to the
"Cleaning the Dirty Water
Tank" section.
Fill the clean solution
tank. Refer to the "Filling
the Clean Solution Tank"
section.
Refer to the "Cleaning the
Brushroll" section, step 4
Turn off the power before
cleaning the brushroll
and any debris that may
be causing the jam. Refer
to the "Cleaning the
Brushroll" section.
s h a r kc l e a n . e u
