VTech DM1111 Guia De Inicio Rapido página 2

Monitor para bebés con alcance mejorado
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
EN
Technical specifications
Frequency control
Crystal controlled PLL synthesizer
Transmit frequency
Baby unit: 1881 - 1897 MHz
Parent unit: 1881 - 1897 MHz
Maximum power used by the transmitter: 0.25W (250 mW)
Channels
10
Nominal effective
Actual operating range may vary according to environmental
range
conditions at the time of use.
Power requirements
Parent unit:
2 x 1.2V AAA size 400mAh Ni-MH
Baby unit power adapter: Output: 6VDC 450mA
Parent unit power adapter: Output: 6VDC 450mA
Specifications are subject to change without notice.
© 2023 VTech Telecomunications Ltd.
All rights reserved. 07/23. DM1111_SNOM_EN_QSG_V4
DM1111
Audio Baby Monitor
Enhanced Range
Quick start guide
,
Ni-battery
2
Important safety instructions
The applied nameplate is located at the
bottom of the baby unit's base.
When using your equipment, basic safety
precautions should always be followed to
reduce the risk of fire, electric shock and
injury, including the following:
1.
Follow all warnings and instructions
marked on the product.
2.
Adult setup is required.
3.
CAUTION: Do not install the baby unit at
a height above 2 metres.
4.
This product is intended as an aid. It
is not a substitute for responsible and
proper adult supervision and should not
be used as such.
5.
This product is not intended for use as a
medical monitor.
6.
Do not use this product near water. For
example, do not use it next to a bath tub,
wash bowl, kitchen sink, laundry tub or
swimming pool, or in a wet basement
or shower.
7.
CAUTION: Use only the battery
provided. There may be a risk of
explosion if a wrong type of battery is
used for the parent unit. The battery
cannot be subjected to high or low
extreme temperature and low air
pressure at high altitude during use,
storage or transportation. Disposal
of battery into fire or a hot oven, or
mechanically crushing or cutting or
the battery can result in an explosion.
Leaving the battery in an extremely high
temperature surrounding environment
can result in an explosion or the
leakage of flammable liquid of gas.
Battery subjected to extremely low air
pressure may result in an explosion or
the leakage of flammable liquid or gas.
Dispose of used battery according to the
instructions.
8.
Use only the adapters included with
this product. Incorrect adapter polarity
or voltage can seriously damage the
product.
9.
Use only the adapters and battery listed
below.
Power adapter information:
Parent unit and baby unit output:
6VDC 450mA
Ten Pao Industrial Co., Ltd.
Model: S003ATV0600045 (EU);
S003ATB0600045 (UK).
Rechargeable batteries
information:
2 x 1.2V AAA size 400mAh NiMH
Corun - KH-AAA400.
10. The power adapters are intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place if it is
plugged into a ceiling, under-the-table
or cabinet outlet.
11. For pluggable equipment, the
socket-outlet shall be installed near the
equipment and shall be easily accessible.
12. Unplug this product from the wall outlet
before cleaning. Do not use liquid or
aerosol cleaners. Use a damp cloth for
cleaning.
13. Do not cut off the power adapters to
replace them with other plugs, as this
causes a hazardous situation.
14. Do not allow anything to rest on the
power cords. Do not install this product
where the cords may be walked on or
crimped.
15. This product should be operated only
from the type of power source indicated
on the marking label. If you are not sure
of the type of power supply in your
home, consult your dealer or local power
company.
16. Do not overload wall outlets or use an
extension cord.
17.
Do not place this product on an unstable
table, shelf, stand or other unstable
surfaces.
18. This product should not be placed in
any area where proper ventilation is not
provided. Slots and openings in the back
or bottom of this product are provided
for ventilation. To protect them from
overheating, these openings must not be
blocked by placing the product on a soft
surface such as a bed, sofa or rug. This
product should never be placed near or
over a radiator or heat register.
19. Never push objects of any kind into this
product through the slots because they
may touch dangerous voltage points or
create a short circuit. Never spill liquid of
any kind on the product.
20. To reduce the risk of electric shock,
do not disassemble this product, but
take it to an authorized service facility.
Opening or removing parts of the
product other than specified access
doors may expose you to dangerous
3
loading