Idiomas disponibles
Idiomas disponibles
To adjust the parallelism of the
cutting deck
This procedure will set the cutting deck in a standard
position.
1. Make sure that the tire pressure is correct. Refer
Tire pressure on page 21 .
to
2. Park the product on a level surface.
3. Turn the outer blade tips to align with the cutting
deck side to side.
WARNING:
cutting deck are sharp and can
cause injury. Use protective gloves.
4. Measure the distance between the ground and
the bottom of the blade tip on the discharge side
of the cutting deck. Make a note of the distance.
5. Measure the distance between the ground and
the bottom of the blade tip on the side opposite
to the discharge side. The distance must be the
same as the distance for the discharge side. If
adjustment is necessary, adjust the 2 front bolts
until the 2 side to side distance are equal.
22
The blades on the
6. Turn the 2 outer blades to align with the cutting
deck front to rear.
7. Adjust the 2 rear nuts until the rear blade tips
are set 1/8–3/8 in. / 3.2-9.5 mm higher in the rear
than in the front blade tips.
8. Measure the distances again to make sure that
the cutting deck has been adjusted correctly.
To adjust the neutral position
The neutral position must be adjusted if 1 of the
2 rear wheels is turning while the parking brake is
engaged.
1. Use a lifting device to lift up the rear part of the
product until the rear wheels are off the ground.
2. Put a stable object below the product and make
sure that the product cannot move forward or
rearward.
3. Engage the parking brake.
4. Start the product.
5. Fold the seat forward.
6. Remove the pin from the front coupler and hold
it.
7. Turn the hex nut by hand clockwise or
counterclockwise until the rear wheel is
stationary.
8. Turn the hex nut in the same direction again and
stop when the rear wheel turns in the opposite
direction. Count the number of turns you do on
the hex nut.
9. Turn the hex nut in the opposite direction, ½ of
the of turns you counted in the step before.
10. Do adjustment for the other side if it is
necessary.
2175 - 001 - 16.06.2023
