Tabla de contenido
Idiomas disponibles
Idiomas disponibles
320-E Press Tool
Battery Charging Procedure:
WARNING
Before using the battery charger, read all the bat-
tery and charger instructions.
1. Locate the charger so the cord and charger will not be
stepped on, tripped over or be subjected to dam-
age. Do not expose charger to wet environment such
as rain or snow.
2. Charge battery cartridge in temperatures above 50°F
(10°C) and below 104°F (40°C). Store tool and battery
cartridge in location where temperatures do not
exceed 120°F (49°C).
3. Plug the battery charger into the proper A/C voltage
source. The charging light will flash in green color
(Figure 4).
WARNING
To avoid electric shock and electrical fires,
never use an extension cord that is damaged or does not
meet the following requirements:
• The cord has pins on line plug that are similar in size
and shape to those of the plug on the charger.
• The cord is rated as "W" or "W-A" if being used
outdoors.
• The cord has sufficient wire thickness (16 AWG
below 100'. If the wire thickness is too small, the
cord may overheat, melting the cord's insulation or
causing nearby objects to ignite.
Do not attempt to use a step-up trans-
WARNING
former, an engine generator or DC power receptacle.
Figure 4 – Battery Charger
NOTE! New batteries are not charged and must be
charged before use.
4. Insert the battery cartridge so that the plus and minus
terminals on the battery cartridge are on the same
sides as their respective markings on the battery
charger. Insert the cartridge fully into the port so that
it rests on the charger port floor.
5. When the battery cartridge is inserted, the charging
light color will change from green to red and charging
6
will begin. The charging light will remain lit steadily
during charging. When charging is completed, the
charging light color will change from red to green.
NOTE! Charging time will be approximately one hour for
2.0 Ah NiCd optional battery or 1
Ah Ni-MH standard equipment battery.
WARNING
types of batteries may burst causing personal injury.
6. After charging, unplug the charger from the power
source. Always cover the battery terminals with the
battery cover when the battery cartridge is not being
used.
Important Charging Notes
1. When you charge a new battery cartridge or a battery
cartridge which has not been used for a long period of
time, it may not accept a full charge. This is a normal
condition and does not indicate a problem. You can
recharge the battery cartridge fully after discharging it
completely and recharging a couple of times.
2. If you charge a battery cartridge from a just-operated
tool or a battery cartridge which has been left in a
location exposed to direct sunlight or heat for a long
time, the charging light may flash in red color. If this
occurs, wait for a while. Charging will begin after the
battery cartridge cools. The battery cartridge will cool
faster if you remove the battery cartridge from the bat-
tery charger.
3. If the charging light flashes alternately in green and
red color, a problem exists and charging is not pos-
sible. The terminals on the charger or battery cartridge
are clogged with dust or the battery cartridge is worn
out or damaged.
Operating Instructions
The 320-E is designed for use only with RIDGID
standard series jaw sets, actuators and press rings.
Use the RIDGID jaw and fitting system intended
for the specific tubing material you are installing.
Keep fingers and hands away from jaws, press
rings and actuator during pressing cycle. Always
wear eye protection to protect your eyes from dirt
and other foreign objects.
Ridge Tool Company
1
/
Charge only Makita® batteries. Other
WARNING
hours for 2.6
4
Capítulos
Tabla de contenido
