Idiomas disponibles
Idiomas disponibles
1
2
Light off Lowest
3. Press the drive-control button or "M" button
to exit the work lights brightness adjustment
mode. If there is no operation for 5 seconds,
the tool will automatically exit the brightness
adjustment mode.
NOTE: While in the work light brightness
adjustment mode, the trigger switch will only
function as a brightness adjustment "button".
The next time the tool is turned on and the
memory function will remember and revert to
the last work light brightness level.
All four work lights will turn off automatically
approximately 10 seconds after the trigger
switch is released.
MODE SELECTION (FIG. 7)
Your tool is equipped with a mode control panel,
located on the foot of the tool. It consists of
the drive-control button, the "M" button, and
indicator lights for working modes.
The drive-control button is used to select among
three modes with preset torque, rotation-speed
(RPM), and impact-speed (IPM) for intended
application. The modes 1, 2, and 3 are the only
modes where the speed is controlled by the
variable-speed trigger switch.
"A" is a special mode, that is designed to be
used both with forward rotation for tightening the
bolts or nuts and reverse rotation for loosening
the bolts or nuts.
In the forward rotation position, the impact
wrench will stop running when the bolt or nut is
pre-tightened, and then the torque wrench can
be used to complete the work. This function has
high work efficiency and the bolt or nut will not
be over-tightened.
In the reverse rotation position, once the bolt
or nut becomes loose, the impact wrench will
stop running to prevent bolt or nut from falling
away.
Using the "M" button:
Press the "M" button directly without touching
the trigger switch. The corresponding indicator
light will illuminate to indicate the active mode.
See more details in the chart below:
3
4
5
Highest
Fig. 6b
6
LED Work Lights
Fig. 7
Drive-control Button
-12-
"M" Button
Indicator Lights
