Pride Mobility MID-SIZE Serie Manual Del Proprietário página 20

I I I . B AT T E R I E S A N D C H A R G I N G
You may need the following to change your batteries:
 Metric/standard socket set and ratchet
 Adjustable wrench
 Screwdriver
WARNING! Do not lift beyond your physical capability. Ask for assistance when necessary while
disassembling or assembling your scooter.
WARNING! Do not pull on electrical harness wires directly to detach them from the scooter.
Always grasp the connector itself when disconnecting the harness to prevent wire damage.
To change batteries in your scooter:
1. Remove the seat and battery shroud. See fi gure 10.
2. Disconnect the battery tie-down strap. See fi gure 11.
3. Disconnect the battery harnesses by depressing the
tabs on the battery harness connectors and pulling
them straight up. See fi gure 11.
4. Disconnect the battery cables from the battery
terminals by sliding back the terminal boots and
unscrewing the nut from the bolt. See fi gure 12.
5. Remove the old batteries from the battery wells.
6. Place a new battery in each battery well. For 710LX
and 710LXW models, face the battery terminals of
each battery rearward. For all other models, face
the battery terminals of each battery opposite each
other and toward the outer sides of the scooter. See
fi gure 11.
7. Connect the red battery cable to the positive (+)
battery terminal on each battery.
8. Connect the black battery cable to the negative (-)
battery terminal on each battery.
9. Reposition the terminal boots over the battery
terminals.
10. Reconnect the battery harnesses.
11. Reconnect the battery tie-down strap.
12. Reinstall the battery shroud and seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact your
local waste disposal agency or your authorized Provider for instructions on disposal and battery recycling,
which is our recommended course of action.
20
Figure 10. Battery Shroud Removal/Installation
1
1
* Models 93 and 104
Mid-size Scooter Series
2