Idiomas disponibles
Idiomas disponibles
PRODUCT SET
Accessories for each model. Рiс. В
1
Pusher ................................................................ 1 pc.
2
Filling tray ........................................................... 1 pc.
3
Cutting block ....................................................... 1 pc.
4
Body ................................................................... 1 pc.
5
Perforated disk 5 mm holes ................................ 1 pc.
6
Perforated disk 3 mm holes ................................. 1 pc.
7
Locking attachment ............................................ 1 pc.
8
Blade .................................................................. 1 pc.
9
Screw .................................................................. 1 pc.
10
Sausage attachment ..................................................1 pc.
11
Locking ring ........................................................ 1 pc.
12
Separator ........................................................... 1 pc.
13
Grater attachment (Sml) ..................................... 1 pc.
14
Grater attachment (Big) ...................................... 1 pc.
15
Slicer attachment ................................................ 1 pc.
16
Pusher ................................................................ 1 pc.
17
Cutting block ....................................................... 1 pc.
Instructions manual ................................................. 1 pc.
ELEMENTS OF DESIGN, Рiс. С-1
Button to remove the cutting block
1
Control panel
2
Assembling the meat grinder, Рiс. C
For mince,
Pic. C-3
1. First, insert the screw
2. Install the blade onto the
screw. Pic. C-2.
3. Install one of the disks
5
6
onto the screw with
,
blades.
4. Tighten the assembled cutting block with a locking attachment
clockwise.
5. Install cutting block
and lock until it clicks.
6. Connect the opening of the cutting block with the filling tray
7. Place the pusher 1 into the filling tray
14
For sausages,
Pic. C-7,C-8
9
into the cutting block
2. Install the screw onto the separator
3. Install onto the separator
the required attachment
.
10
3
in the meat grinder, turn it counterclockwise
.
1
UTILIZATION, Рiс. C
Control panel, Рiс. C-1
- START/STOP button. Press START/STOP button
to start the meat grinder engine.
re
- REVERSE button. If something got stuck in
the meat grinder, turn it off by pressing START/
STOP button. Press and hold REVERSE
button, so that the cutting screw begin to rotate
into the opposite direction, pushing the stuck
product out.
Before first use, wipe the device with a soft, dry
cloth. The rest of the parts wash with warm water
and detergent. Dry all the parts. Before assembling
or disassembling the device and / or removing
attachments,
unplugged.
The blades are very sharp, be careful.
Automatic engine protection
Automatic protection works to protect the engine
from overheating. In case when automatic protection
turned on, the device will stop and buttons on the
control panel won't work. Let the device cool for 10
minutes.
Maximum time of continued use of the de-
vice – 5 minutes. The interval between the
cycles should be 10 minutes.
For
meatballs,
Pic. C-5,C-6
3
.
12
.
3. Install the
locking ring
.
11
7
, turning it
.
2
make
sure
that
For vegetables,
Pic. C-4
1. Insert the required nozzle
the cutting block
17
.
2. Secure the cutting block
grinder, turn counterclockwise and lock
until it clicks.
3. Place the pusher
15
into the cutting
block
16
.
the
device
is
13
14
15
into
,
,
17
in the meat
