Idiomas disponibles
Idiomas disponibles
Operation
OPERATING YOUR FAN
Your fan is equipped with a remote control to operate the fan speed
and lights of your new ceiling fan.
The speed setting for warm or cool weather depends on factors such
as the room size, ceiling height, number of fans and so on.
The fan is shipped from the factory with the reversing switch
positioned to circulate air downward. If airflow is desired in the
opposite direction, turn your fan off and wait for the blades to stop
turning, then slide the reversing switch (located in switch cup) to the
opposite position, and turn the fan on again. The fan blades will turn in
the opposite direction and reverse airflow.
NOTE: Wait for the fan to stop before reversing the direction of the
blade rotation.
Warm weather - (Forward) A downward airflow creates a cooling effect.
This allows you to set your air conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting without
affecting your comfort.
USING THE REMOTE CONTROL
NOTE: This remote is equipped with a 16-code combination. To
prevent possible interference from or to other remote units, such
as garage door openers, car alarms, or security systems, change
the combination code but be sure that the code on both the remote
control and receiver in the fan are the same.
□
Install the 12-Volt battery (included) into the battery
compartment of the remote control (J).
□
Press the desired button on the remote control (J) to operate
the fan:
□
"3" button: Press to set the fan speed to high.
□
"2" button: Press to set the fan speed to medium.
□
"1" button: Press to set the fan speed to low.
□
Power button (UU): Press to turn the fan off.
□
Light button (VV): Press and release immediately to turn
the light on or off. Press and hold to dim or brighten the
bulbs to the desired level and then release (the dimmer
function is for Tungsten bulbs only).
14
UU
V V
