Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Lights
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
NOTE: Notice the location of the fan's slide switch. This is the
switch used to change the fan's directional rotation. For more
information on the operation of this switch, see Operating
Your Fan on page 14.
NOTE: This light kit cannot be transferred to another fan.
□
Remove the three light kit mounting screws (RR) on the black
bracket below the fan-motor assembly (E).
□
Plug the molded adaptor plug from the light kit (F) to the
molded adaptor plug from the fan-motor assembly (E). Make
sure the connector latch close properly.
□
Align the holes in the light kit (F) with the holes in the black
bracket below the fan-motor assembly (E) and install using
the light kit mounting screws (RR) that were removed in the
first step above.
Assembly - Assembling the Fan Without the Light Kit
1
Assembling the fan without the
light kit
□
Remove the three light kit mounting screws (RR) on the black
bracket below the fan-motor assembly (E).
□
In order to use the fan without the light kit, remove the switch
cup (2) from the top of the light kit fitter assembly (F) by
removing the center hex nut inside the switch cup cover, and
then thread the switch cup cover off of the threaded nipple on
the top of the light kit fitter assembly (F).
□
Press the plastic plug (GG) (provided) into the center hole of
the switch cup (2).
□
Position the switch cup (2) onto the black bracket and reinstall
the light kit mounting screws (RR).
2
E
RR
F
13
Installing the bulbs and attaching
the glass bowl
CAUTION: Do not over tighten the hex nut, overtightening the
hex nut may cause the glass to break.
□
Remove the rubber washer (P), hex nut (Q), bottom cover (R),
and finial (S) from the threaded nipple of the light kit fitter
assembly (F).
□
With power off, install the three CFL Light bulb, (14-Watt maxi-
mum included) (L) by screwing into the light bulb sockets.
□
Position the glass bowl (I) over the threaded nipple.
□
Re-install the rubber washer (P), hex nut (Q), and bottom cover
(R) to the threaded nipple to secure the glass shade properly.
□
Re-install and tighten the finial (S).
L
P
R
2
Please contact 1-877-527-0313 for further assistance.
E
F
I
Q
S
E
RR
GG
HAMPTONBAY.COM
