Maintenance; Daily Maintenance; To Adjust The Drill Motor Carriage - Husqvarna Ds150 Manual Del Usuario

Introduction
WARNING:
safety chapter before you do maintenance
on the product.
WARNING:
disconnect the power cord before you do

maintenance.

Daily maintenance

• Make sure that the nuts and screws are tight.
• Clean the external surfaces.
• Make sure that the feed lever moves without
resistance.
• Make sure that the gears move easily and do not
cause a noise.
• Examine the drill column for wear and damage.
• Make sure that the drill motor carriage moves easily
and that there is no play against the drill column.
To clean and lubricate the product
CAUTION:
stand, it can become damaged.
1. Remove the drill motor.
2. Clean the product with a high-pressure washer and
then remove remaining water with a dry cloth.
3. Lubricate the moving parts of the product. Apply
grease to the contact surfaces to prevent corrosion.

To adjust the drill motor carriage

If there is distance between the drill column and the
drill motor carriage, the drill motor carriage must be
adjusted.
12
Maintenance
Read and understand the
To prevent injury,
If you do not clean the drill
1. Remove the plastic covers from the top and the
bottom of the drill motor carriage.
2. Loosen the screw that holds the roller shafts.
3. Turn the top guide wheel clockwise with a flat
screwdriver. The top guide wheel moves nearer to
the driill column.
1341 - 005 - 28.09.2023