Idiomas disponibles
Idiomas disponibles
201112105
93-2709.qxd
Basic Operation
Buttons
"POWER" Button
"MUTE/TEST" Button
12/29/2011
4:28 PM
• To turn the UPS ON: with the UPS plugged into a live AC wall outlet,* press and
hold the POWER button for about two seconds.** Release the button. If utility
power is absent, you can "cold-start" the UPS (i.e.: turn it ON and supply power
for a limited time from its batteries***) by pressing and holding the POWER
button for about two seconds.**
• To turn the UPS OFF: with the UPS ON and receiving utility power, press and
hold the POWER button for one second.** Then unplug the UPS from the wall
outlet. The UPS will be completely OFF.
* After you plug the UPS into a live AC outlet, the UPS will automatically charge its batteries, but will not
supply power to its outlets until it is turned ON. ** The alarm will beep once briefly after the indicated inter-
val has passed. *** If fully charged.
• To Silence (or "Mute") UPS Alarms: briefly press and release the MUTE/TEST
button.* Note: continuous alarms (warning you to immediately shut down
connected equipment) cannot be silenced.
• To Run a Self-Test: with your UPS plugged in and turned ON, press and hold the
MUTE/TEST button for two seconds.* Continue holding the button until the
alarm beeps several times and the UPS performs a self test. See "Results of a Self-
Test" below. Note: you can leave connected equipment on during a self-test. Your
UPS, however, will not perform a self-test if it is not turned ON (see "POWER"
Button description).
CAUTION! Do not unplug your UPS to test its batteries. this will remove safe
electrical grounding and may introduce a damaging surge into your network
connections.
Results of a Self-Test: The test will last approximately 10 seconds as the UPS
switches to battery to test its load capacity and battery charge. The "POWER" LED
will be flashing and the "OUTPUT LOAD LEVEL" and "BATTERY CHARGE"
LEDs will be lit and the UPS alarm will sound.
• If the "OUTPUT LOAD LEVEL" LED remains lit red and the alarm continues to
sound after the test, the UPS's outlets are overloaded. To clear the overload,
unplug some of your equipment and run the self-test repeatedly until the
"OUTPUT LOAD LEVEL" LED is no longer lit red and the alarm is no longer
sounding.
CAUTION! Any overload that is not corrected by the user immediately
following a self-test may cause the UPS to shut down and cease supplying
output power in the event of a blackout or severe brownout.
• If the "BATTERY WARNING" LED remains lit and the alarm continues to sound
after the test, the UPS batteries need to be recharged or replaced. Allow the UPS
to recharge continuously for 12 hours, and repeat the self-test. If the LED remains
lit, contact Tripp Lite for service. If your UPS requires battery replacement, visit
www.tripplite.com/support/battery/index.cfm to locate the specific Tripp Lite
replacement battery for your UPS.
* The alarm will beep once briefly after the indicated interval has passed.
5
Page 5
