Idiomas disponibles
Idiomas disponibles
OPERATION
Blowing Feature
Your Vac features a Blower Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blower Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Hose Release Button of the
Tug-A-Long Positive Locking Hose with
Dual-Flex End with the Ridges on the
Blower Port. Push the Hose End straight
into the Blower Port until the Hose
Release Button fully engages the Blower
Port Ridges.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
WARNING:
!
Always
wear
complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before using as
a blower.
WARNING:
!
To reduce the risk of injury to
bystanders, keep them clear of
blowing debris.
CAUTION:
!
Wear a dust mask if blowing creates
dust which might be inhaled.
CAUTION:
!
To reduce the risk of hearing damage,
wear ear protectors when using the
Vac/Blower for extended time or in a
noisy area.
SP7071-2 HD1200M0.indb 26
safety
eyewear
Hose Release Button
Tug-A-Long Positive
Locking Hose with
Dual-Flex
Remove Hose:
1. Rotate Hose End in either direction to
disengage Blower Port Ridges.
2. Press the Hose Release Button and
pull the Hose End straight out of the
Blower Port.
1
REMOVE HOSE
INSERT HOSE
Blower Port
Ridges
Hose Release Button
26
Blower
Port
Ridges
Swivel End of Hose
Extension
Wand
(Optional)
1
2
8/16/19 3:00 PM
